Fountain Care

Signature Maple Panel Fountain

Always assemble your fountain on a firm and level surface, so it is stable and safe, and to ensure an even flow of water. It is not advisable to constantly run your fountain as this will shorten the life of the pump, and waste water through evaporation, wind and splash.

Ensure your fountain is filled with water, and the pump is always fully submerged. You may need to top up the water periodically, as allowing the fountain to run low on water will cause the pump to run dry, overheat and fail, which is not covered by warranty.

Remember to regularly clean or change the water in your fountain so the pump does not get clogged with debris or algae, as this is also not covered by warranty. Algaecide can be added to fountain water to prevent growth and prolong the life of your pump. In winter, never allow ice to form in the bowls of your fountain, as this may cause cracking. Instead, drain the fountain and store indoors during colder months.

To clean the pump, first disconnect it from the power supply and remove it from the fountain. Remove the inlet cover from the front of the pump, and gently grip the impeller to pull out the rotor assembly. Rinse the rotor and rotor housing with clean water to remove any debris, then dry with paper towel and reassemble the parts carefully. If in doubt about any
electrical connections, please consult a qualified electrician.

Assembly Instructions

For more information on how to install and care for your water feature, download the Assembly and Care Instructions for your fountain from below.

Signature

Signature - Kimberlite Water Feature
Signature - Village Pump Fountain
Signature - Ubud Buddha Fountain
Signature - Floral Pillar Fountain
Signature - Garden Gate Fountain
Signature - Jackson Waterfall Fountain
Signature - Lotus Buddha Fountain
Signature - Plaza Cascade Fountain

Water Magic

Please visit the Water Magic site for Assembly instructions and video for the Water Magic range